21
Throttle Function Setting (optional)
Throttle Walk Assist Enable/Disable(optional)
HL means throttle walk assist. HL:N means function disable ,HL:Y
means function enable .
When HL=Y, use the throttle to realize walk assist state. Press
UP/DOWN to select Y/N. If N is selected, press MODE to confirm
and turn to throttle vector enable setting, otherwise there is no
response.
Hold MODE to confirm the selection and turn back to personalized
parameter setting interface. HL default value is N.
Throttle Enable/Disable setting
Throttle Vector Enable/Disable(optional)
HND means throttle. HF：Y means throttle vector enable , HF：N
means throttle vector disable. If HF
：Y is selected, when turning the
throttle, the maximum output of the motor can only reach the
speed of corresponding PAS level shown on the display; if HF
：N is
selected, it means when turning the throttle, speed is not limited
by the PAS level shown on the display, it can reach the rated
To Next Page
Loading...
Need help?
General
