driven equipment, read the work-
shop manual and review the safety
labels attached to the equipment.
WARNING
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height and
check that at least 1/4 of the
total length of the telescopic
section of the drive shaft is en-
gaged.
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
T66O122a
4. When operating stationary P.T.O
driven equipment, always apply
the tractor parking brake and place
chocks behind and in front of the
rear wheels. Stay clear of all rotat-
ing parts.
5. Do not attach a P.T.O dirven imple-
ment if the implements safety
shields are damaged or not in
place. Rotating shafts are an en-
tanglement hazard.
(1) 3-point hitch lowering speed knob
(A) “FAST” (B) “SLOW”
WHEN USING THE 3-POINT HITCH
1. Use the 3-point hitch only with
equipment designed for 3-point
hitch usage.
2. When using a 3-point hitch mount-
ed implement, be sure to install the
proper counterbalance weight on
the front of the tractor.
3. When transporting on the road,
set the implement lowering control
in the "LOCK" position to hold the
implement in the raised position.
M46O105a
To Next Page
Loading...
Need help?
General
