KP310V1.0 Controller Operation Manual
- 12 -
6.1 Alarm
In the following alarms, relevant LED twinkles, but genset keeps running.
No. Type Description
1 Oil filter overtime
When oil filter is overtime than the maintenance value, there will
be an oil filter overtime alarm, maintenance LED twinkles.
2 Fuel filter overtime
When fuel filter is overtime than the maintenance value, there
will be a fuel filter overtime alarm, maintenance LED
twinkles.
3 Air filter overtime
When air filter is overtime than the maintenance value, there will
be a air filter overtime alarm, maintenance LED twinkles.
4
Over battery
voltage
When the battery voltage is larger than the set value, battery
LED
twinkles.
5
Under battery
voltage
When the battery voltage is lower than the set value, battery
LED
twinkles.
6 Charging faults
When the charging voltage is lower than the set value, battery
LED
twinkles.
6.2 Time delayed stop alarms
After detecting the time delayed stop alarms, relevant LED twinkles, and genset will be stopped
after a delayed time.
No. Type Description
1 Over Current 1
If genset current is larger than Over Current 1, over current LED
twinkles, genset will be stopped after a delayed time.
Customers can set values to disable the protection.
2 Over Current 2
If genset current is larger than Over Current 2, over current LED
twinkles, genset will be stopped after a delayed time.
Customers can set values to disable the protection.
Note: if output configuration is set as “8-Time delayed stop alarms”, breaker will be open in
event of over current fault, and genset will be stopped after a delayed time.
To Next Page
Loading...
Need help?
General