Kobalt SM1815LW User Manual

31
29
30
BEFORE LEAVING THE SAW
● Never leave tool running unattended. Turn
power OFF. Wait for all moving parts to stop.
● Make workshop childproof. Lock the shop.
Disconnect master switches. Store tool away
from children and other unqualied users.
WARNING: To avoid injury from materials
being thrown, always unplug the saw to avoid
accidental starting and remove small pieces
of material from the table cavity.
MITER CUT (FIG. 29)
● When a miter cut is required, unlock the
miter table by turning the miter handle (1)
counterclockwise.
● While holding the miter handle, lift up on the
positive stop locking lever (2).
● Rotate the miter table to the right or left with
the miter handle.
● When the table is in the desired position, as
shown on the miter scale (3), release the
positive stop locking lever and tighten the
miter handle. The table is now locked at the
desired angle. Positive stops are provided at
0°, 15°, 22.5°, 31.6° and 45°.
● Turn the laser guide on and position the
workpiece on the table for pre-alignment of
your cut.
IMPORTANT: Always tighten the miter table
lock handle before performing every cutting
operation.
BEVEL CUT (FIG. 30)
● When a bevel cut is required, loosen the
bevel lock handle (1) by turning it clockwise.
● Tilt the cutting head to the desired angle, as
shown on the bevel scale (2).
● The blade can be positioned at any angle,
from a 90° straight cut (0° on the scale) to
a 45° left bevel. Tighten the bevel lock
handle (1) to lock the cutting head in position.
Positive stops are provided at 0° and 45°.
● Turn the laser guide on and position the
workpiece on the table for pre-alignment of
your cut.
3
2
1
1
2

Kobalt SM1815LW Specifications

General

Brand	Kobalt
Model	SM1815LW
Category	Saw
Language	English