33
33
34
35
CUTTING BOWED MATERIAL (FIG. 33)
A bowed workpiece must be positioned against
the fence and secured with a clamp (1) before
cutting as shown. Do not position workpiece
incorrectly or try to cut the workpiece without the
support of the fence. This will cause the blade to
bind and could result in personal injury.
CUTTING GROOVES (FIG. 34)
WARNING:
DO NOT USE A DADO BLADE,
use only the standard saw blade for this
operation.
● Mark lines to identify the width and depth of
the desired cut on the workpiece and put the
workpiece on the table and aim the inside
tip of the blade at the line. Use a clamp to
secure the workpiece on the table.
● Lower the cutting head so the tip of the
blade touches the top surface of the
workpiece at the marked line.
● While holding the upper arm in position, turn
the stop knob (2) until it touches the stop
plate (1). (SEE “SETTING CUTTING
DEPTH” on page 22).
● Cut two parallel grooves as shown.
WORKPIECE SUPPORT (FIG. 35)
Long pieces need extra support. The support
should be placed under the workpiece. Keep
your hand holding the workpiece positioned
6-11/16 in. or more away from the blade. The
support must let the workpiece lay at on the
work table during the cutting operation.
NOTE: When mounted on a at surface, the saw
table is 2-11/16 in. high.
2-11/16 in.
Cut these
grooves
with saw
Use a chisel
to cut out the
middle
1
1
2
To Next Page
Loading...
Need help?
General