39
SAWDUST
Periodically, sawdust will accumulate under the
worktable and base. This could cause difculty in
the movement of the worktable when setting up
a miter cut. Frequently blow out or vacuum up
the sawdust.
If blowing sawdust, wear proper eye protection to
keep debris from blowing into eyes.
LUBRICATION (FIG. 41)
All the motor bearings in this tool are lubricated
with a sufcient amount of high-grade lubricant
for the life of the unit under normal operating
conditions; therefore, no further lubrication
is required.
Lubricate the following as necessary:
Chop pivot: Apply light machine oil to points
indicated in illustration.
Central pivot of plastic guard: Use light
household oil (sewing machine oil) on metal-to-
metal or metal-to-plastic guard contact areas
as required for smooth, quiet operation. Avoid
excessive oil as sawdust will cling to it.
FREE WARNING LABEL REPLACEMENT:
If your warning labels become illegible or
are missing, call 1-800-243-5114 for a free
replacements.
DO NOT replace the power cord. If you have
any problem or questions concerning the power
cord, call the Customer Service Department at
1-888-356-2258.
CAUTION
41
Add oil here and on opposite side
Central pivot of
plastic guard
WARNING
To Next Page
Loading...
Need help?
General