Kohler K-4026T User Manual

-12-
O. Secure the Vitreous Shell
CAUTION: Risk of product
damage. Do not overtighten the
screws when tightening. The
vitreous shell may chip or break
if the screws are overtightened.
Insert a screw through both grommets.
Insert a screw in both of the provided
holes and tighten. Do not overtighten.
Place a cap over each screw. The
caps should be flush with the exterior
of the shell.
O.
Screw
Cap
Grommet
Fig.#20
20
Cut a recess in the access cover using a utility knife at the
spot marked on the access cover.
Place the access cover over the opening in the back of the
toilet.
Caulk around the base of toilet and caulk the access cover to
the vitreous shell.
Fig.#21
21
Access
Opening
Caulk Base Of Toilet.
Toilet Back
Cut With Utility Knife.
Access Cover
COMPLETE THE INSTALLATION
N. Check Operation
NOTE:
NOTE:
The flushing mechanism works
best if it is quickly tapped, not held
down for an extended period of time.
There is an approximate eight-
second delay between the flush and
the tank refilling.
Flush the toilet and check for proper
operation.
Refer to "Homeowner's Guide" to
check whether the bidet seat functions
well.
Refer to the troubleshooting chart if the
toilet does not function properly.
N.
Fig.#19
19
Push to Flush.
1144585-T01-A

Kohler K-4026T Specifications

General

Brand	Kohler
Model	K-4026T
Category	Toilets
Language	English