D. Install the T-Bolts
Install two new 8mm (5/16") diameter
T-bolts into the floor flange.
Do not use white cement or high lime
content cements to install this toilet.
The expansion of cement due to a rise
in temperature may make the toilet
crack or cause damage. Kohler is not
responsible for any damage caused by
installation with the use of cement.
Install the Electrical Service
NOTE: This product is designed for installation with the
electrical supply located through the wall. Both types are
illustrated. Refer to the dimensional information for your
chosen installation.
Follow the dimensional information exactly when installing a
hardwire electrical supply.
Install the Water Service
NOTE:
NOTE:
This product is designed for installation with the water
supply located through the wall. Both types are illustrated.
Refer to the dimensional information for your chosen
installation.
A floor mounted water supply stop must be no higher
than 70mm from the floor.
Install the water supply. If you are installing a floor supply,
study the dimensional information illustrated carefully.
C. Install the Electrical Service and Water
Supply
DANGER: Risk of electric shock.
DANGER: Risk of electrical shock. For plug-in
installations/wall-mounted electrical supply:
DANGER: Risk of electrical shock. For hardwire
installations/through-floor electrical supply:
Disconnect power
before servicing.
Connect only to a properly-grounded, grounding-type
receptacle which is protected by a Ground-Fault
Circuit-Interrupter (GFCI). Do not remove the
grounding pin or use a grounding adapter.
Connect only to a properly-grounded, dedicated
220~240V, 16A, 50Hz circuit protected by a Class A
Ground-Fault Circuit-Interrupter (GFCI) or Earth-
Leakage Circuit-Breaker (ELCB).
D. T
8mm (5/16") T
70mm
C.
/
(GFCI)
220~240 16 50
T-Bolts
T
Floor Flange
Fig.#9
9
-7-
1144585-T01-A
To Next Page
Loading...
Need help?
General
