b. Take out the tank assembly from the vitreous shell and
put it on the floor.
c. Remove the EPE foam from the tank.
b.
c.
d. Remove the gasket and the collar. d.
EPE Foam
C. Take out the tank.
a. Place an 800mm x 600mm cushion on the floor and
then put the whole toilet on it.
Operate with care to avoid scratching the surface
of the vitreous shell.
Note:
C.
a. 800mm x 600mm
Actuation Switch
Fig.#5a
5a
Fig.#5b
5b
Fig.#5c
5c
-5-
D. Place every part on the floor and ready for installation. D.
Fig.#6
6
Collar
Gasket
1144585-T01-A
To Next Page
Loading...
Need help?
General
