Komatsu AX20 User Manual

32. REPLACEMENT PROCEDURES
4-30
32. REPLACEMENT PROCEDURES
32.1 REPLACING FUSES AND RELAYS
32.1.1 CHASSIS FUSES (ALL TRUCKS)
NOTICE
• When replacing the fuses, always turn OFF the electric power first (turn the starting switch to the
OFF position).
• Always replace the fuses with a fuse of the same capacity.
The CHASSIS fuses are used to protect the electrical components and wiring from burning out and are located in a
fusebox located to the left of the steering column and below the dashboard panel of dials and gauges.
1. Turn the starting switch to the OFF position.
2. Open the cover of the fuse box and replace necessary fuses inside. To remove the cover from the fuse box,
push the side face of the cover lightly with your fingers and pull it out.
The fuse number in the tables below correspond from right to left in the illustration. Check the relationship
between the fuses and the electrical components when replacing.
.
Fuse capacity for lift trucks without
Operator Presence System
No.
Capacity
(Amp)
Related Electrical
Component
(1)
EPA gas: 5
Diesel: 10
Starter relay
(neutral safety switch)
(5) 10 Meter
(6) 10 Back-up lamp
(9) 10 Horn
(10) 15 Lamps
(11) 15 Stop lamp
Fuse capacity for lift trucks with
Operator Presence System
No.
Capacity
(Amp)
Related Electrical
Component
(1)
EPA gas: 5
Diesel: 10
Starter relay
(neutral safety switch)
(4) 15 Main relay
(5) 10 Back-up lamp
(6) 10 Meter
(9) 10 Horn
(10) 15 Lamps
(11) 15 Stop lamp
LIFT TRUCK WITHOUT
OPERATOR PRESENCE SYSTEM
LIFT TRUCK WITH
OPERATOR PRESENCE SYSTEM
METER
10A
HORN
10A
BACK
LAMP
10A
STOP
LAMP
15A
FUSE
PULLER
LAMP
15A
MAIN
RELAY
15A
OPT
(IGN)
OPT
(IGN)
OPT
(BAT)
OPT
(BAT)
STARTER
RELAY
5A
SPARE SPARE SPARE

Komatsu AX20 Specifications

General

Brand	Komatsu
Model	AX20
Category	Forklifts
Language	English