10. HANDLING RADIO CONTROL OPERATION
3-16
10. HANDLING RADIO CONTROL
To ensure that the radio control operations can be carried out safely, they must be carried out in the following
order. If this order is not followed, the radio control cannot be operated, so be sure that you fully understand the
correct order before operating.
Set radio control/on-board selector
switch to RADIO CONTROL
Set parking lever on left side of operator's seat to
FREE position (raised)
Set radio control/on-board selector switch to ON-BOARD
Set fuel control dial inside cab to MIN position
Checks before starting
Turn starting switch ON
Transmitter power ON
Start engine
Start radio control operation
Radio control operation
Emergency stop, radio control power OFF
Set parking lever to LOCK position (lowered)
Turn starting switch OFF (on machine)
Checks after finishing
(Turn switch on
machine to ON position)
On-board
operation
On-board
operation
When this is done, the spe
range display on the monit
panel shows "PR".
When this is done, the spe
range display on the monit
panel shows "NR".
When this is done, the eng
stops.
1
1
2
3
2