SERVICE PROCEDURE MAINTENANCE
4-44
CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL
WARNING
The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool
down before starting the operation.
1. Remove oil level plug(1) and check whether the final
drive case is filled with oil to lower edge of the plug hole.
2. If the oil level is still too low, add engine oil through the
plug hole until the oil overflows.
CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL
WARNING
● When removing the oil filler cap, oil may spurt out, so
stop the engine and wait for the oil temperature to go
down, then turn the cap slowly to release the internal
pressure before removing the cap.
● If oil has been added to above proper range, stop the
engine and wait for the hydraulic oil to cool down,
then drain the excess oil from the drain plug.
NOTICE
● Do not add oil if the level is above the H line. This will
damage the hydraulic equipment and cause the oil to
spurt out.
● Always lock the cap with the key.
1. Lower the blade to the ground, stop the engine and wait
for about 5 minutes before checking oil level. If oil level is
between H and L in sight gauge(G).
2. If the level is below the L mark, add engine oil through oil
filler(F).
3. After adding oil, be sure to screw on the oil filler cap and
lock it with the key.
To Next Page
Loading...
Need help?
General
