86
S
ETUP MENU
LCD MONITOR BRIGHTNESS
Monitor brightness can be adjusted in 11 levels.
Brightness can be set individually for viewfinder
and direct viewing in the recording mode. Turn the
mode switch to the appropriate position before
opening the brightness option in section 1 of the
setup menu (p. 84). Also see page 28.
Use the left/right keys of the controller to adjust
brightness, the monitor image changes
accordingly. Press the central button of the
controller to set the level.
AUTO POWER SAVE
To conserve battery power, the camera will shut down if no operation is made within a
certain period. The length of the auto-power-save period can be changed to 1, 3, 5, or 10
minutes. When the camera is connected to a computer, the auto-power-save period is
fixed at ten minutes. Auto power save is set in section 1 of the setup menu (p. 84).
Set LCD brightness
:select
:enter
Low High
An image can be displayed on the monitor after it is captured.
When used with the continuous-advance drive mode (p. 46),
thumbnails of the last six images in the series will be
displayed. Instant playback is activated section 1 of the setup
menu (p. 84). A playback period of two or ten seconds can be
selected. To cancel the playback and save the image before
the end of the playback period, press the shutter-release
button partway down.
INSTANT PLAYBACK
Single still images can be previewed immediately after being captured without instant playback
active. Simply continue to hold the shutter-release button down after taking the picture to display
the image. Release the shutter button to end the playback.
Camera Notes
To Next Page
Loading...
Need help?
General
