99
The number in the image file name may not correspond to the frame number of the
image. As images are deleted in the camera, the frame counter will adjust itself to show
the number of images on the card and reassign the frame numbers accordingly. The
serial numbers used with image files will not change when an image is deleted. When a
new image is recorded, it will be assigned a number one greater than the largest serial
number in the folder. File serial numbers can be controlled with the file-number-memory
function in section 2 of the setup menu (p. 87).
Image files contain Exif tag data. This data includes the time and date the image was
recorded as well as the camera settings used. This data can be viewed with the camera
or the DiMAGE Viewer software.
If a camera image is opened in an image-processing application that does not support
Exif tags, and then the image is saved overwriting the original data, the Exif tag
information is erased. Some Exif compatible applications rewrite the Exif data preventing
the DiMAGE Viewer from reading it. When using software other than the DiMAGE
Viewer, always make a backup copy of the image files to protect the Exif tag data.
To view images correctly on your computer, the monitor’s color space may need to be
adjusted. Refer to your computer manual on how to calibrate the display to the following
requirements: sRGB, with a color temperature of 6500K, and a gamma of 2.2. Changes
made to the captured image with the camera’s contrast controls will affect any color-
matching software in use.
AUTO POWER SAVE - DATA-TRANSFER MODE
If the camera does not receive a read or write command within ten minutes, it will shut
down to save power. When the camera shuts down, an unsafe-removal-of-device
warning may appear on the computer monitor. Click “OK.” Neither the camera or
computer will be damaged in this operation. Turn off the camera with the main switch.
Remake the USB connection by turning the camera on.
To Next Page
Loading...
Need help?
General
