Krups EVIDENCE PLUS EA894T User Manual

PREPARING MILKY DRINKS VIA DIRECT ACCESS
Please note: when starting each drink, the machine will take into account the settings for the last drink that was made.
The stages of preparation of the drink:
- Bean grinding
- Compaction of the grinding
- Percolation
- Preheating phase to froth the milk
Possible settings
You can:
- Prepare one or two cups at the same time.
- Increase the strength of the coffee by pressing DARK .
- Add an espresso coffee in your DRINK by pressing EXTRA SHOT .
- Adjust the coffee volume
- Adjust the length of time for frothing the milk.
Making a Cappuccino
A cappuccino is made up of 1/3 creamy froth, 1/3 coffee and 1/3 hot milk.
- Connect the milk tube Fig. 13 to the right side of the “One Touch Cappuccino” block.
- Immerse the other end of the tube (slanted side) in a container lled with milk or directly in your milk bottle or
milk pot (according to model). Fig. 14
- Place the cup or cups under the coffee nozzles. Fig. 15
- Press the cappuccino button. Fig. 16
- The preparation begins with frothing the milk
You can adjust your frothing time using the navigation buttons which allow the quantity of milk and
froth to be varied.
- This process continues with the ow of coffee
You can adjust your volume of coffee using the navigation buttons if you wish.
- Your drink is ready. Fig. 17.
Making a Latte macchiato
A latte macchiato is made up of a higher dose of milk than a cappuccino. 1/4 of creamy froth, 1/4 of coffee and 2/4
of hot milk.
We recommend that you use a cup of approximately 250 ml.
To make a latte macchiato you can follow the same steps as for cappuccino by pressing the latte macchiato button.
Fig. 18.
Making a Caffe latte
A caffe latte is made up of an espresso mixed with a large dose of milk and topped with froth tasting slightly of coffee.
We recommend that you use a cup of approximately 250ml.
To make a caffe latte you can follow the same steps as for cappuccino by pressing the caffe latte button.
For this recipe the coffee is poured in rst and then the machine delivers the frothy milk.
Rinsing milk after making milk-based drinks.
The screen shows “Rinse milk? “ at the end of each preparation.
- Press to perform rinsing.
- During milk rinsing, you are required to systematically dismantle and clean the milk tube and connector
with hot water. Fig. 21-25
- For the best results, it is advised to clean the “One Touch Cappuccino” removable block regularly (see
general maintenance chapter).
!
Important: If you note a change in the quality of your milk froth, do not hesitate to repeat the rinsing and
cleaning process: indeed a milk system that is not well maintained may cause this type of problem.
30

Krups EVIDENCE PLUS EA894T Specifications

General

Control type	Touch
Display type	OLED
Product color	Titanium
Built-in display	Yes
Product type	Espresso machine
Capacity in cups	2 cups
Milk adding type	Automatic
Number of spouts	2
Coffee input type	-
Coffee maker type	Fully-auto
Country of origin	France
Appliance placement	Countertop
Water tank capacity	2.3 L
Coffee beans capacity	260 g
Maximum operating pressure	15 bar
Reservoir for brewed coffee	Cup
Ground coffee container capacity	9 cups
Number of coffee strength settings	3
Pallet width	800 mm
Pallet height	2174 mm
Pallet length	1200 mm
Pallet weight	391752 g
Quantity per pallet	40 pc(s)
Quantity per pallet layer	8 pc(s)
Quantity per intermodal container (20ft)	448 pc(s)
Quantity per intermodal container (40ft)	924 pc(s)
Quantity per intermodal container (40ft, HC)	1155 pc(s)
Package depth	381 mm
Package width	287 mm
Package height	484 mm
Package weight	10750 g
Number of programs	14

Weight and Dimensions

Depth	372 mm
Width	240 mm
Height	363 mm
Weight	8400 g