13 SERVICE WORK ON THE CHASSIS 115
Guideline
Screw, chain guide M6 5 Nm
(3.7 lbf ft)
Loctite
®
243™
Finishing work
– Remove the vehicle from the center stand. ( p. 105)
13.10 Checking/rectifying the fluid level of the hydraulic clutch
Info
The fluid level rises with increasing wear of the clutch lining disc.
Do not use brake fluid.
S00270-10
– Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
1
.
–
Remove cover
2
with membrane
3
.
– Check the fluid level.
Fluid level below top edge of container 4 mm (0.16 in)
» If the coolant level does not meet specifications:
– Correct the fluid level of the hydraulic clutch.
Hydraulic fluid (15) ( p. 216)
– Position the cover with the membrane. Mount and tighten the screws.
To Next Page
Loading...
Need help?
General
