To Next Page

To Previous Page

13 SERVICE WORK ON THE CHASSIS 125

307823-11

–

Mount and tighten screw

Guideline

Screw, mask spoiler M5x17 3.5 Nm

(2.58 lbf ft)

– Repeat the operation on the opposite side.

Finishing work

– Install the tank cover. ( p. 128)

– Install the front side cover. ( p. 119)

– Mount the seat. ( p. 107)

13.18 Removing the front fender

S00323-10

–

Remove holder

from the front fender.

–

Remove screws

– Remove the fender in a forward direction.

Info

Pay attention to the brake lines.

Default Chapter5
- Table of Contents5
1 Means of Representation10
- Symbols Used10
- Formats Used10
2 Safety Advice11
- Use Definition - Intended Use11
- Degrees of Risk and Symbols12
- Overview of Labels14
- Reporting Safety Defects19
- Noise Emission Warranty19
- Operating Noise Warning20
- Consumer Rights20
- Tampering Warning20
- Safe Operation21
- Protective Clothing22
- Work Rules22
- Environment22
- Owner's Manual23
3 Important Information24
- Warranty24
- Operating and Auxiliary Substances24
- Spare Parts, Accessories24
- Service24
- Figures25
- Customer Service25
4 View of Vehicle26
- View of Vehicle, Front Left Side (Vehicle Differs Slightly from Photo)26
- View of Vehicle, Rear Right Side (Vehicle Differs Slightly from Photo)28
5 Serial Numbers30
- Chassis Number30
- Type Label30
- Key Number31
- Engine Number32
- Fork Part Number32
- Shock Absorber Part Number33
6 Controls34
- Clutch Lever34
- Hand Brake Lever34
- Throttle Grip35
- Switch on the Left Side of the Handlebar35
- Combination Switch35
- Light Switch36
- Hazard Warning Flasher Switch36
- Menu Switch37
- Turn Signal Switch37
- Horn Button38
- Switch on the Right Side of the Handlebar38
- Emergency off Switch38
- Electric Starter Button39
- Ignition/Steering Lock39
- Immobilizer40
- Socket for Electrical Accessories40
- Opening the Filler Cap41
- Closing the Filler Cap42
- Fuel Cocks43
- Opening the Storage Compartment44
- Closing the Storage Compartment44
- Seat Lock45
- Tool Set45
- Grab Handles46
- Luggage Rack Plate46
- Passenger Footrests47
- Shift Lever47
- Side Stand48
- Center Stand49
7 Combination Instrument50
- Overview50
- Activation and Test50
- Matrix Display51
- Segment Display51
- Indicator Lamps52
- Message on the Matrix Display53
- Shift Warning Light54
- Service Display55
- Matrix Display Menu55
- Favorites55
- Trip 156
- Trip 256
- General Info57
- TPMS" (Optional)57
- Set Favorites58
- Settings58
- Warnings59
- Heat Grip" (Optional)59
- Mtc/Abs60
- Drive Mode60
- Menu Overview62
- Language63
- Distance64
- Temp64
- Volume65
- Pressure65
- Clock/Date66
- Fuel Cons66
- Drl67
- Shift Light67
- Quick Shift68
- Heat Grips68
8 Ergonomics69
- Handlebar Position69
- Adjusting the Handlebar Position69
- Adjusting the Wind Shield70
- Adjusting the Basic Setting of the Clutch Lever72
- Adjusting the Basic Position of the Hand Brake Lever72
- Rider Footrests73
- Adjusting the Footrests73
- Foot Brake Lever75
- Adjusting the Basic Position of the Foot Brake Lever75
- Checking the Basic Position of the Shift Lever77
- Adjusting the Basic Position of the Shift Lever77
9 Preparing for Use79
- Advice on First Use79
- Running in the Engine80
- Loading the Vehicle81
10 Riding Instructions83
- Checks and Maintenance Measures When Preparing for Use83
- Starting84
- Starting off85
- Shifting, Riding85
- Applying the Brakes89
- Stopping, Parking91
- Transport92
- Refueling93
11 Service Schedule95
- Additional Information95
- Required Work95
- Recommended Work98
12 Suspension Setting99
- Fork/Shock Absorber99
- Adjusting the Compression Damping of the Fork99
- Adjusting the Rebound Damping of the Fork100
- Adjusting the Spring Preload of the Fork101
- Compression Damping of the Shock Absorber102
- Adjusting the Low-Speed Compression Damping of the Shock Absorber102
- Adjusting the High-Speed Compression Damping of the Shock Absorber103
- Adjusting the Rebound Damping of the Shock Absorber104
- Adjusting the Spring Preload of the Shock Absorber105
13 Service Work on the Chassis107
- Raising the Vehicle with the Center Stand107
- Removing the Vehicle from the Center Stand107
- Removing the Seat108
- Mounting the Seat109
- Checking for Chain Dirt109
- Cleaning the Chain110
- Checking the Chain Tension111
- Adjusting the Chain Tension112
- Checking the Chain, Rear Sprocket and Engine Sprocket114
- Checking/Rectifying the Fluid Level of the Hydraulic Clutch117
- Checking the Steering Head Bearing Play118
- Removing the Bottom Triple Clamp Cover119
- Installing the Bottom Triple Clamp Cover119
- Removing the Front Side Cover120
- Installing the Front Side Cover121
- Removing the Mask Spoiler122
- Installing the Mask Spoiler125
- Removing the Front Fender127
- Installing the Front Fender128
- Removing the Tank Cover128
- Installing the Tank Cover130
- Removing the Wind Shield131
- Installing the Wind Shield132
14 Brake System133
- Abs/Antilock Brake System133
- Checking the Brake Discs135
- Checking the Brake Fluid Level of the Front Brake136
- Adding Front Brake Fluid136
- Checking the Front Brake Linings138
- Checking the Rear Brake Fluid Level139
- Adding Rear Brake Fluid140
- Checking the Rear Brake Linings142
15 Wheels, Tires143
- Removing the Front Wheel143
- Installing the Front Wheel145
- Removing the Rear Wheel147
- Installing the Rear Wheel149
- Checking the Rear Hub Rubber Dampers151
- Checking the Tire Condition153
- Checking the Tire Air Pressure154
- Checking Spoke Tension155
16 Electrical System157
- Daytime Running Light157
- Removing the Battery157
- Installing the Battery159
- Recharging the Battery160
- Changing the Main Fuse164
- Changing the Fuses in the Fuse Box166
- Removing the Headlight Mask with the Headlight168
- Refitting the Headlight Mask with the Headlight169
- Changing the Low Beam Bulb170
- Changing the High Beam Bulb171
- Changing the Turn Signal Bulb173
- Checking the Headlight Setting174
- Adjusting the Headlight Range175
- Activating/Deactivating the Ignition Key176
17 Cooling System181
- Checking the Coolant Level in the Compensating Tank181
- Correcting the Coolant Level in the Compensating Tank182
18 Engine Tuning184
- Drive Mode184
- Mtc/Motorcycle Traction Control184
19 Service Work on the Engine186
- Checking the Engine Oil Level186
- Changing the Engine Oil and Filter, Cleaning the Oil Screens187
- Adding Engine Oil191
20 Cleaning, Care194
- Cleaning Motorcycle194
- Checks and Maintenance Steps for Winter Operation196
21 Storage198
- Preparing for Use after Storage199
22 Troubleshooting200
23 Technical Data202
- Engine202
- Engine Tightening Torques203
- Capacities207
- Engine Oil207
- Coolant207
- Fuel207
- Chassis207
- Electrical System209
- Tires210
- Fork210
- Shock Absorber211
- Chassis Tightening Torques212
24 Substances216
25 Auxiliary Substances220
26 Standards222
- Index223

Brand	KTM
Model	1190 ADVENTURE R
Category	Motorcycle
Language	English

KTM 1190 ADVENTURE R User Manual

Table of Contents

Questions and Answers:

KTM 1190 ADVENTURE R Specifications

Related product manuals