9 RIDING INSTRUCTIONS
40
Note
Engine failure Overheating damages the engine.
– If the coolant temperature warning is displayed, stop immediately and take care not to endanger yourself or
other traffic participants in the process.
– Allow the engine and cooling system to cool down.
– Check and, if necessary, correct the coolant level on the cooling system while it is in a cooled state.
Info
If unusual noises occur while riding, stop immediately (taking care not to endanger yourself or other road
users in the process), switch off the engine and contact an authorized KTM workshop.
401950-11
– Shift into a higher gear when conditions allow (incline, road
situation, etc.).
– Release the throttle while simultaneously pulling the clutch
lever, shift into the next gear, release the clutch lever, and
open the throttle.
Info
The gear positions can be seen in the figure. The neu-
tral or idle position is between the first and second
gears. First gear is used for starting off or for steep
inclines.
The operating temperature is reached when 4 bars of
the temperature indicator light up.
– Only open the throttle as much as the engine can handle –
abrupt throttle grip opening increases fuel consumption.
Accelerate only up to a speed suitable for the road surface and
weather conditions. Particularly in bends, do not shift, and
accelerate very carefully.
– Brake if necessary and close the throttle at the same time in
order to shift down.
– Pull clutch lever and shift into a lower gear, release the clutch
lever slowly, and open the throttle or shift again.
– Switch off the engine if you are likely to be running at idle
speed or stationary for a long time.
– If the malfunction indicator lamp lights up during a trip,
stop immediately (taking care not to endanger yourself or other
road users in the process), switch off the engine, and contact
an authorized KTM workshop.
9.5 Applying the brakes
Warning
Danger of accidents Moisture and dirt impair the brake system.
– Brake carefully several times to dry out and remove dirt from the brake linings and the brake discs.
Warning
Danger of accidents A spongy pressure point on the front or rear brake reduces braking efficiency.
– Check the brake system and do not continue riding until the problem is eliminated. (Your authorized
KTM workshop will be glad to help.)
To Next Page
Loading...
Need help?
General
