15 COOLING SYSTEM 134
B00768-10
Main work
– Stand the motorcycle upright.
– Place a suitable container under the engine.
–
Remove screw
.
– Remove the radiator cap.
– Completely drain the coolant.
–
Mount screw
with a new seal ring and tighten it.
Guideline
Plug, water pump drain hole M6 8 Nm (5.9 lbf ft)
15.5 Filling/bleeding the cooling system x
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water immedi-
ately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swallowed,
contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of children.
B01552-11
–
Remove radiator cap
.
To Next Page
Loading...
Need help?
General
