7 COMBINATION INSTRUMENT
34
Info
The TR2 value can also be corrected manually during the
journey with the button and the button .
If 999.9 is exceeded, the value of TR2 is automatically
reset to 0.0.
Press the but-
ton for 2–3
seconds.
Increases value of TR2.
Briefly press
the button .
Increases value of TR2.
Press the but-
ton for 2–3
seconds.
Reduces value of TR2.
Briefly press
the button .
Reduces value of TR2.
Wait 10 - 12
seconds.
Stores and closes the Setup menu.
7.19 Display mode SPEED/A1 (average speed 1)
400325-01
–
Repeatedly press the button briefly until A1 appears at the
top right of the display.
A1 (average speed 1) shows the average speed calculated using
TR1 (trip master 1) and S1 (stop watch 1).
The calculation of this value is activated by the first impulse of the
wheel speed sensor and ends 3 seconds after the last impulse.
Press the but-
ton for 2–3
seconds.
Displays of TR1, A1 and S1 are reset to 0.0.
Briefly press
the button .
Next display mode
Press the but-
ton for 2–3
seconds.
No function
Briefly press
the button .
No function
7.20 Display mode SPEED/A2 (average speed 2)
400326-01
– Repeatedly press the button briefly until A2 appears at the
top right of the display.
A2 (average speed 2) shows the average speed on the basis of the
current speed if the stop watch S2 (stop watch 2) is running.
Info
The displayed value can differ from the actual average
speed if S2 was not stopped after the ride.
Briefly press
the button .
Next display mode
To Next Page
Loading...
Need help?
General
