KTM 350 SX-F 2017 User Manual

11 SERVICE WORK ON THE CHASSIS 56
S01242-11
(All SX‑F models)
–
Mount and tighten screw
2
with the rubber bushing.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
S01239-11
–
Plug in connector
3
for the fuel pump.
– Remove the wash cap set. Thoroughly clean the plug-in connection of the fuel
line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve!
–
Lubricate the O-ring and connect plug-in connection
4
for the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.
S01248-11
(XC‑F US)
–
Mount and tighten screw
2
with the rubber bushing.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
S01246-11
–
Plug in connector
3
for the fuel pump.
– Remove the wash cap set. Thoroughly clean the plug-in connection of the fuel
line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve!
–
Lubricate the O-ring and connect plug-in connection
4
for the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.
Finishing work
– Mount the seat. ( p. 48)
11.34 Checking for chain dirt accumulation
400678-01
– Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
– Clean the chain. ( p. 57)

KTM 350 SX-F 2017 Specifications

General

Brand	KTM
Model	350 SX-F 2017
Category	Motorcycle
Language	English