11 SERVICE WORK ON THE CHASSIS 42
11.15 Greasing the steering head bearing x
800010-10
–
Remove the lower triple clamp. x ( p. 38)
–
Install the lower triple clamp. x ( p. 39)
11.16 Removing the start number plate
C00174-10
– Remove screw 1 and take off the clamp.
– Remove screw 2. Take off the start number plate.
11.17 Installing the start number plate
C00174-11
– Position the start number plate. Mount and tighten screw 1.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
The holding lugs engage.
– Position the brake line and clamp. Mount and tighten screw 2.
11.18 Removing the front fender
Preparatory work
– Remove the start number plate. ( p. 42)
C00152-10
Main work
– Remove screws 1 and 2. Remove the front fender.
To Next Page
Loading...
Need help?
General
