KTM 450 SX-F EU User Manual

11 SERVICE WORK ON THE CHASSIS 55
11.41 Adjusting the chain guide x
B00348-10
– Loosen screw 1. Remove screw 2. Swing the chain guide down.
Condition
Number of teeth: ≤ 44 teeth
– Insert collar bushing 3 into drill hole A. Position the chain guide.
– Mount and tighten screw 2. Tighten screw 1.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
Condition
Number of teeth: ≥ 45 teeth
– Insert collar bushing 3 into drill hole B. Position the chain guide.
– Mount and tighten screw 2. Tighten screw 1.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
11.42 Checking the frame x
401519-01
– Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame. x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by KTM.
11.43 Checking the swingarm x
401520-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm. x
Info
A damaged swingarm must always be changed. Repair of the
swingarm is not authorized by KTM.
11.44 Checking the throttle cable routing
Preparatory work
– Remove the seat. ( p. 44)
–
Remove the fuel tank. x ( p. 49)
S00139-10
Main work
– Check the throttle cable routing.
Both throttle cables must be routed to the throttle valve body side by side behind
the handlebars and above the fuel tank bracket.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.

KTM 450 SX-F EU Specifications

General

Brand	KTM
Model	450 SX-F EU
Category	Motorcycle
Language	English