11 SERVICE WORK ON THE CHASSIS 51
C00165-10
– Mount and tighten screws 2 with the collar bushing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
C00234-10
– Connect the electrical plug-in connection 3.
– Remove the wash cap set. Thoroughly clean the plug-in connection of the fuel line
using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
– Lubricate the O-ring and connect plug-in connection 4 of the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
– Mount the seat. ( p. 44)
11.36 Checking for chain dirt accumulation
400678-01
– Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
– Clean the chain. ( p. 51)
11.37 Cleaning the chain
Warning
Danger of accidents Oil or grease on the tires reduces their grip.
– Remove oil and grease with a suitable cleaning material.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
– Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
The service life of the chain depends largely on its maintenance.
To Next Page
Loading...
Need help?
General
