SERVICE WORK ON THE CHASSIS 11
65
101947-10
Main work
–
Loosen nut
1
.
–
Adjust the chain tension by turning adjusting nuts
2
left and
right.
Guideline
Chain tension 5 … 8 mm (0.2 … 0.31 in)
Turn adjusting nuts
2
equally on the left and right. The
rear wheel must be aligned with the front wheel.
–
Make sure that the chain adjuster support plates
3
are in
contact with adjusting nuts
2
.
–
Tighten nut
1
.
Guideline
Nut, rear wheel spin-
dle
M12x1 40 Nm (29.5 lbf ft)
11.36 Checking the chain, rear sprocket, engine sprocket and chain guide
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 42)
– Remove the engine sprocket cover. ( p. 61)
100896-10
Main work
– Check the engine sprocket cover for wear.
» If the engine sprocket cover is worn through in the marked
area
A
:
– Change the engine sprocket cover.
400227-01
– Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket or engine sprocket is worn:
– Change the drivetrain kit.
Info
The engine sprocket, rear sprocket, and chain
should always be replaced together.
When fitting the chain joint, always make sure
that the closed side of the joint faces forward
(riding direction).
– Check the chain for wear.
» If the chain is worn:
– Change the drivetrain kit.
Info
When a new chain is mounted, the rear sprocket
and engine sprocket should also be changed.
New chains wear out faster on old, worn sprock-
ets.
To Next Page
Loading...
Need help?
General
