WHEELS, TIRES 13
79
H00935-10
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact surfaces
A
of the spacers.
Long-life grease ( p. 110)
– Insert the spacers.
V00247-10
–
Clean and grease wheel spindle
2
.
Long-life grease ( p. 110)
– Position the front wheel.
The brake linings are correctly positioned.
– Insert the wheel spindle.
–
Tighten screws
3
.
Guideline
Screw, fork stub M6 10 Nm (7.4 lbf ft)
V00219-11
–
Mount and tighten screw
4
.
Guideline
Screw, front
wheel spindle
M10 40 Nm (29.5 lbf ft)
Loctite
®
243™
– Remove the motorcycle from the lift stand. ( p. 39)
V00248-10
– Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Loosen screws
3
.
– Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
3
.
Guideline
Screw, fork stub M6 10 Nm (7.4 lbf ft)
13.3 Removing the rear wheel
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 39)
To Next Page
Loading...
Need help?
General
