20 STORAGE 168
– Raise the motorcycle with the front wheel stand. ( p. 79)
– Cover the motorcycle with a tarp or similar cover that is permeable to air.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm
up properly, the water vapor produced during combustion condenses and causes
valves and exhaust system to rust.
20.2 Preparing for use after storage
401059-01
– Take the motorcycle off of the front wheel stand. ( p. 80)
– Take the motorcycle off of the rear wheel stand. ( p. 78)
– Recharge the battery. ( p. 131)
– Install the battery. ( p. 130)
– Set the clock. ( p. 53)
– Perform checks and maintenance steps when preparing for use. ( p. 60)
– Take a test ride.
To Next Page
Loading...
Need help?
General
