7 COMBINATION INSTRUMENT 55
The display RPM 1 goes out and the set speed is stored.
7.23 Adjusting the shift speed RPM 2
Condition
The ignition is on.
The motorcycle is stationary.
401308-01
– Press the MODE button briefly and repeatedly until TRIP 2 appears on the display.
– Press the SET button for 5 - 10 seconds.
The display RPM 2 appears.
Info
The engine speed can be set at intervals of 50.
RPM 2 is the engine speed above which the shift warning light lights up con-
stantly.
The speed RPM 2 must always be higher than the speed RPM 1.
– Set the speed with the MODE and SET buttons.
Info
The MODE button increases the value.
The SET button decreases the value.
– Do not activate the two buttons for approx. 15 seconds.
The display RPM 2 goes out and the set speed is stored.
To Next Page
Loading...
Need help?
General
