Kubota B2401DT User Manual

NOTE :
• If the implement control valve has a relief valve,
the tank port flow from implement should be
connected to the port located on the right hand
side of transmission case.
DUAL REMOTE HYDRAULIC
CONTROL SYSTEM [B2401DT
ONLY]
The tractor is equipped with the double-acting 2-
segment hydraulic control valve for front loader.
To apply the hydraulic power take-off for general
attachments, keep the following point in mind.
1. Control lever and hydraulic hose
connections
Connect the control lever in its specified direction and
the hydraulic hoses to their specified ports.
(1) Loader / remote control
valve lever
(A) Right
(B) Left
(C) Up
(D) Down
[a] R1
[b] R2
[1] White
[2] Yellow
[3] Red
[4] Blue
[Hydraulic outlet ports of first segment]
Lever Up Down
Port
[1] In
Returning
Out
Pressure
[2] Out
Pressure
In
Returning
[Hydraulic outlet ports of second segment]
Lever Right Left
Port
[3] Out
Pressure
In
Returning
[4] In
Returning
Out
Pressure
IMPORTANT :
To avoid damage of the attachments:
• Do not connect attachments through the
hydraulic motor to the [3] and [4] ports. If the
control lever is moved to the regeneration
position (R1), the seals on the hydraulic motor
will be damaged.
• This control valve is provided with the
regeneration position. When the [3] and [4]
ports are used to take off hydraulic power for
the hydraulic cylinder, be sure to connect the
[3] port to the head-end side port of the
hydraulic cylinder.
• Make the following connections when using this
valve to take off hydraulic power for the
hydraulic cylinder.
Colored coupler
Hydraulic cylinder port
[2] Yellow, [4] Blue Head-end side
[1] White, [3] Red Rod-end side
2. Loader / remote control valve
lever
1. Before moving the lever, make sure that the
hydraulic hoses for attachments are connected.
DUAL REMOTE HYDRAULIC CONTROL SYSTEM [B2401DT ONLY] HYDRAULIC UNIT
B2401DT, B2401DTWO, B2401DTN
47

Kubota B2401DT Specifications

General

Brand	Kubota
Model	B2401DT
Category	Tractor
Language	English