2. Retighten the lock nut.
NOTE :
Consult your local KUBOTA Dealer for further
details.
(1) Adjusting screw (2) Lock nut
2. Changing transmission fluid /
replacing hydraulic oil filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before changing the
oil filter cartridge.
• Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plug.
(1) Drain plug (Except
B2401DTN)
(2) Drain plugs (both sides)
3. Remove the oil filter.
(1) Hydraulic oil filter
4. Put a film of clean transmission oil on rubber seal of
new filter.
5. Tighten the filter quickly until it contacts the
mounting surface.
Tighten filter by hand an additional 1/2 turn only.
PERIODIC SERVICE EVERY 400 HOURS
B2401DT, B2401DTWO, B2401DTN
To Next Page
Loading...
Need help?
General
