26 HYDRAULIC UNIT
HYDRAULIC UNIT
3-POINT HITCH CONTROL SYSTEM
■ Hydraulic Control
Operating the hydraulic control lever actuates the
hydraulic lift arm, which controls the elevation of 3-point
hitch mounted implement.
To lower implement, move the hydraulic control lever
forward; to raise it, move the hydraulic control lever
rearward.
Hydraulic control lever is automatically returned to neutral
position when the implement is raised at top position or
down at lowest position.
(1) Hydraulic control lever
IMPORTANT:
(A) nDOWW
(N) "NEUTRAL"
(B) "UP"
• If the· ·3-point hitch can not be raised by setting the
hydraulic control lever to the UP position after long
term storage or when changing the transmission oil,
follow these air bleeding procedures ..
(1) Stop the engine.
(2) Set the hydraulic control lever to the down
position and start the engine.
(3) Operate the engine at low idle speed for at least
30 seconds to bleed air from the system.
• · Do not_ operate until the engine is warmed up. If
operation is attempted when the engine is still cold, the
•
~raulic system may be damaged.
rioises are heard when implement is lifting after the
hydraulic control lever has been activated, the
hydraulic mechanism is not adjusted properly.
{r:!.nless corrected the unit will be damaged.
·contact your KUBOTA Dealer for adjustment.
■
Implement
Lowering Limit
The implement lowering limit can be changed by shifting
the locker.
(1) Feedback rod (2) Locker (3) Nuts
(4) Spring (5) Bolt
• Lower Limit
The lower limit can be changed by adjusting the
position of locker. Shifting the locker backward raises
the lower limit and shifting it forward lowers the lower
limit.
To Next Page
Loading...
Need help?
General
