19CHECKS BEFORE START
BAuto Idle Control Switch
The switch is used to enable and disable the auto idle
control.
BThrottle Potentiometer
1. Sit down on the operator's seat and turn the throttle
potentiometer clockwise (toward the high speed), and
the engine revs up.
2. To stop the engine, turn the throttle potentiometer fully
toward the low speed and keep the engine at the idling
speed. Then set the starter key to the "STOP"
position.
BTravel Speed Switch
Travel speed will increase when this switch is pushed
down.
Switching the dual travel speed:
1. Press the travel speed switch. The buzzer beeps twice
and the travel speed changes from low to high. The
symbol lights up.
2. Press the travel speed switch again, and the buzzer
beeps once and the travel speed changes from high
speed to low. The symbol goes out.
A When activating the travel speed switch, it must be
pushed down completely.
A Each time the travel speed switch is pressed, the
travel speed is switched between low and high.
A Enable: Press the auto idle control switch. When
the auto idle control is on, the auto idle
control lamp stays on.
A Disable: Press the auto idle control switch once
again. Now the auto idle control is
deactivated
(The auto idle control lamp goes out.)
(1) Auto idle control switch
(2) Auto idle control lamp
(1) Throttle potentiometer
(1) Travel speed switch
(2) Speed indicator light
To Next Page
Need help?
General
