Cooling system inspection
1. Check the coolant level in the coolant
reservoir when the engine is cold as the
coolant level will vary with engine
temperature. The coolant level should be
between the maximum and minimum marks.
2. If the level is low, remove the coolant
reservoir cap, and then add coolant or distilled
water to raise it to the specified level.
3. If your ATV overheats, see page 121 for
details.
FULL
LOW
(1)
(2)
(3)
(1) Coolant reservoir cap
(2) Maximum level mark
(3) Minimum level mark
Hard water or salt water is harmful to the
engine. You may use distilled water if rou
can not get soft water.
CAUTION:
1. If water is added, have a KYMCO dealer
check the antifreeze content of the coolant
as soon as possible.
2. The radiator fan operation is completely
automatic. It is switched on or off according
to the coolant temperature in the radiator.
NOTE:
120
To Next Page
Loading...
Need help?
General
