CLEANING AND STORAGE
A. CLEANING
Frequent, thorough cleaning of your machine
will not only enhance its appearance but will
improve its general performance and extend the
useful life of many components.
1. Before cleaning the machine:
A. Block off the end of the exhaust pipe to
prevent water entry. A plastic bag and
strong rubber band may be used.
B. Make sure the spark plug and all filler
caps are properly installed.
2. If the engine case is excessively greasy,
apply degreaser with a paint brush. Do not
apply degreaser to the chain, sprockets or
wheel axles.
3. Rinse the dirt and degreaser off with a
garden hose. Use only enough pressure to
do the job.
Excessive water pressure may cause water
seepage and deterioration of wheel
bearings, brakes, transmission seals and
electrical devices. Many expensive repair
bills have resulted from improper high
pressure detergent applications such as
those available in coin-operated car
washers.
4. Once the majority of the dirt has been
hosed off, wash all surfaces with warm
water and mild, detergent-type soap. An old
toothbrush or bottle brush is handy for
hard-to-get-at places.
5. Rinse the machine off immediately with
clean water and dry all surfaces with a
chamois, clean towel or soft absorbent
cloth.
6. Dry the chain and lubricate it to prevent
rust.
133
CAUTION:
To Next Page
Loading...
Need help?
General
