4-27
POTENTIAL HAZARD
Improper use of the locking steering.
WHAT CAN HAPPEN
The ATV could cause loss of control or overturn.
HOW TO AVOID THE HAZARD
Always be sure you have released the locking steering
handlebar and steering lock key is taken out before you begin
to ride.
Never lock the steering handlebar, when the engine is starting.
4.12. DRIVE SELECT LEVER
The drive select lever is used to shift your ATV into the low, high,
neutral, reverse and park positions. Refer to CH 5.1.1 for drive
select lever adjustment and operation.
(L) Low (R) Reverse
(H) High (P) Park
(N) Neutral
NOTE
Apply the rear brake and shift the shift lever into P position
before turning off the engine when parking the vehicle on an
incline if you park on an incline with shift lever in H, L or R
position, vehicle weight will make it difficult to shift into neutral.
If the other system isn’t a 12-volt system or with a negative
ground, both vehicles can be damaged.
To Next Page
Loading...
Need help?
General
