－27－
(9) HORN/LIGHTS INSPECTION
Turn the ignition switch to the " " position and push
the check if it sounds.
Headlight/Taillight Inspection:
Start the engine and turn on the headlight switch to
check if the headlight and taillight are good and check
the light shells for dirt and damage.
Stoplight Inspection:
Apply the front and rear brake levers respectively to
check if the stoplight is good. And also check the stop
light shell for dirt and damage.
Turn Signal Light Inspection:
Operate the turn signal switch to make sure whether
the right/left front and rear turn signal lights can wink
and buzz. Also check the light shells for dirt and damage.
Headlight Taillight/ Stoplight Turn signal light
Horn button
horn button to
Replace any dirty or damaged lights with new ones to
avoid danger during riding.
CAUTION:
To Next Page
Loading...
Need help?
General