－48－
(8) BRAKE FLUID LEVEL INSPECTION /REFILLING
Remove the two screws from the brake fluid tank and
take off the cover.
Add recommended brake fluid DOT 4 into the tank until
the fluid level reaches the upper limit and then put on
the cover and tighten the screws.
Recommended Brake Fluid: DOT 4
Do not mix brake fluid of different brands. It may cause
brake failure and is very dangerous. When refilling
brake fluid, use towels to cover and protect the painted
and coated surfaces. (Replace at 10000km or every
year.)
(9) RUBBER COVER INSPECTION FOR WIRE AND
CABLE
The cable cores are protected by the rubber cover
outside the connector. Check the rubber cover
frequently for proper installation.
When washing the scooter, do not flush the rubber
cover directly or brush it. Use a wet rag to wipe off dirt
and dust.
Rubber Cover
Check Points
CAUTION:
To Next Page
Loading...
Need help?
General