－42－
(3) BATTERY
This model adopts the battery which needs no refilling
of distilled water.
When cleaning the terminal terminals, remove the
screws attaching the battery cover on the met-in box
and then open the battery cover.
When battery terminals are corroded, take out the
battery for cleaning.
After cleaning, apply a thin coat of grease or vaseline
to battery terminals and then install the battery.
Never open the closed-type battery electrolyte cap.
If the scooter will not be used for a long time, the
battery will discharge electricity by itself. Remove the
battery and put it in a cool place after it is fully charged
to prevent electricity leakage.
If the scooter will not be used for a long time, remove
the negative (-) terminal.
Do not smoke or allow flames or sparks near the
battery while removing and installing it.
Turn off the ignition switch before removal or
installation.
The negative (-) terminal shall be removed first and
the positive (+) terminal shall be installed first.
Tighten the loose terminal nuts securely.
CAUTION:
Battery Charger
To Next Page
Loading...
Need help?
General
