57
10. Install the oil strainer screen, spring and oil strainer screen
cap. Tighten the cap to the specified torque.
Oil strainer screen cap torque: 11 lb-ft (15 N-m)
11. Fill the crankcase with the recommended grade engine oil
(see page 52).
Engine oil capacity - Xciting 500i or 500Ri: 2.2 qt (2.1 L)
Engine oil capacity - Xciting 300i or 300Ri: 0.95 qt (0.9 L)
Engine oil capacity - Xciting 250i or 250Ri: 0.95 qt (0.9 L)
NOTE: Amounts are after draining the oil and filter, only.
12. Install the oil filler cap/dipstick.
13. Start the engine and let it idle for 2 - 3 minutes.
14. Stop the engine and check the oil level on the dipstick with
the scooter parked on the center stand, on level ground.
15. Adjust the oil level as required (so the oil reaches the up-
per mark on the dipstick). Replace the dipstick and inspect
for any leaks.
Transmission fluid change
1. Place the scooter on its center stand.
2. Remove the transmission fluid drain bolt 1.
11
11
1
11
11
1
MAINTENANCE
250/300i & 250/300Ri models
500i & 500Ri models
To Next Page
Need help?
General
