64
MAINTENANCE
Front and rear suspension inspection
1. Check the fork assembly by squeezing the front brake
lever and pump the fork up and down vigorously. Suspen-
sion action should be smooth, and there should be no
fluid leakage.
2. Swing arm bearings should be checked by pushing hard
against the side of the rear wheel while the scooter is on
the center stand. Free play indicates worn bearings.
3. Carefully inspect all front and rear suspension fasteners
for tightness.
NOTE: If you discover any irregularities during your sus-
pension inspection, take your scooter to a KYMCO dealer
immediately for service.
Interlock function check:
Check the side stand ignition cut-of f system:
1. Place the scooter on its center stand.
Side stand
Your scooter’s side stand is not only necessary when you park,
but it contains an important safety feature. This feature cuts-
off the ignition if you try to ride the scooter when the side
stand is down. Per the maintenance schedule, you should per-
form the following side stand inspection.
Physical inspection
Check the spring for damage or loss of tension. Check the
metal stand itself to make sure it is not damaged or bent.
Check that the stand has free, smooth movement from the
UP to the DOWN position.
2. Put the side stand up and start the engine.
3. Lower the side stand. The engine should stop as you put
the side stand down.
NOTE: If the side stand system does not operate as de-
scribed, see your KYMCO dealer for service.
To Next Page
Loading...
Need help?
General