27
CONTROLS & FEATURES
The side stand safety interlock switch should remain
functional on the scooter at all times and should be ser-
viced by a KYMCO dealer immediately if it is faulty.
Always check the operation of the side stand safety in-
terlock system before riding your scooter.
Riding your scooter with the side stand incompletely
retracted (in the “UP” position) can cause an accident.
Always retract the side stand fully before riding.
Suspension
Each shock absorber 4 on your Yager 200i scooter has an
adjustment collar that allows you to set the spring preload for
different loads or riding conditions.
Use a pin spanner tool 5 to adjust the rear shock spring
preload. Be certain to adjust both shock absorber’s spring
preload to the same setting.
44
44
4
55
55
5
Headlight aim adjuster
The vertical headlight aim on your Yager 200i scooter can be
adjusted to compensate for different loads or riding conditions.
1. Remove the rubber plug 6 to expose the adjuster screw
2. Turn the screw 7 clockwise or counterclockwise to set the
headlight aim at the desired level.
3. Replace the rubber plug
To adjust the headlight aim on your scooter:
66
66
6
77
77
7
Do not set your scooter’s headlight aim so it will inter-
fere with the eyesight of other traffic. Obey local laws
and regulations when using your scooter’s headlights.
To Next Page
Loading...
Need help?
General
