48
MAINTENANCE
Engine oil filter replacment
The engine oil filter must be replaced periodically per the ser-
vice maintenance schedule (see pages 39 - 41).
1. Remove the oil dipstick 1 from the right crankcase cover.
11
11
1
2. Place a suitable container (drain pan) under the left crank-
case and remove the oil filter cap 2.
3. The oil filter 3 and the oil filter spring 4 will come out when
the cap 2 is removed. Let the engine oil drain out.
4. Discard the oil filter.
5. Make sure the oil filter cap O-ring 5 is good condition.
22
22
2
22
22
2
33
33
3
44
44
4
55
55
5
Only use a genuine KYMCO genuine oil filter element,
or an oil filter element of equivalent quality, on your
scooter. Using the wrong KYMCO oil filter element, or a
non-KYMCO oil filter element which is not of equivalent
quality, may cause engine damage.
6. Install the oil filter, the oil filter spring, the oil filter cap O-
ring and the oil filter cap. Torque the cap’s nuts to the speci-
fied torque.
Oil filter cap nut torque: 8.6 lb-ft (12 N.m)
To Next Page
Loading...
Need help?
General
