49
Engine oil capacity: 0.95 qt (0.8 L)
Engine oil viscosity: SAE 15W-40
7. Add the specified engine oil through the oil filler/dipstick
hole (amount is after draining).
8. Replace the oil filler/dipstick and tighten it securely.
9. Start the engine and let it idle for 2 - 3 minutes.
Do not overfill the engine with oil. Overfilling the en-
gine can cause oil leaks and/or oil contamination of
the air filter element. Always make sure the oil level is
above the "L" mark but not higher than the "F" mark
on the dipstick.
10. Stop the engine and recheck the oil level. Make sure the
oil level is at the upper mark âFâ on the dip stick 1 when
the scooter is parked upright on level ground. Make sure
there are no oil leaks and reinstall the dip stick.
F
L
11
11
1
MAINTENANCE
NOTE: Always dispose of used engine oil and oil filters in
a environmentally responsible manner. Take the drained
oil and old filters in a sealed container to your local recy-
cling center or service station for reclamation. Do not
throw the oil or oil filter in the trash. Do not pour the oil on
the ground, or pour it down a drain.
To Next Page
Loading...
Need help?
General
