blow the hose with mouth.
If air can be blown into the hose, the auto
bystarter is faulty and replace it with a new
one.
AUTO BYSTARTER REMOVAL
Remove the auto bystarter cover.
Remove the two auto bystarter set plate
screws to remove the auto bystarter.
Check the auto bystarter valve and needle for
wear or damage.
Check the O-ring for wear or damage.
AUTO BYSTARTER INSTALLATION
Install the auto bystarter into the carburetor body
until it bottoms..
Install the set plate and then tighten the two screws.
To Next Page
Loading...
Need help?
General
