Section 7 OPTIONAL EQUIPMENT
7-2
Setting originals in the Document Processor
1 Adjust the original insert guides to fit the width of
original(s) to be copied.
IMPORTANT!
• Before setting new originals, make sure that there are
no other originals remaining on the original eject table.
Originals left on the eject table can cause other
originals to misfeed.
• Be sure to fan through the originals a few times to
separate the sheets before setting them in the
Document Processor.
2 Arrange the originals in order and set them face up on the
original table. Slide the leading edge of the originals
securely into the Document Processor as far as they will go.
IMPORTANT!
• Be sure to set only a number of originals that is LESS
than the level indicator on inside of the rear insert
guide. Setting more than the acceptable number of
originals can cause the originals to misfeed.
• To keep ejected originals from falling off the copier,
open the ejection extension when using larger sized
originals such as 8
1/2" × 13" (Oficio II), 8 1/2" × 14"
(Legal) and Folio.
To Next Page
Loading...
Need help?
General
