2P7/2R0/3PN
1-5-5
(2) Detaching and refitting the power cord connector cover and the interface cover
Procedure
1. Remove the power cord cover by
sliding it.
2. Release the hook of the interface cover
and then remove during twisting it.
Figure 1-5-7
(3) Detaching and refitting the right upper cover
Procedure
1. Remove two screws.
2. Release the hook A by twisting right
upper cover.
3. Release two hooks B by sliding the right
upper cover upward and then remove it.
Figure 1-5-8
Interface cover
Power cord
connector cover
Rear cover
Hook
Right upper cover
Front cover
Screw
Screw
Hooks B
Hook A
To Next Page
Loading...
Need help?
General