Printer Properties
31
3 Select the check box of an optional device shown in blue, (such as the
Finisher options),
and a sub-dialog box appears with additional setting details.
4In the
Memory box, select the memory capacity of your printer. This setting is required to
optimize the downloading of printer fonts.
Punch Settings Select the check box for the finishing device the Device Options list, such as Finisher or
Multi-Finisher. The
Punch Unit Setting dialog box appears. Double-click the option to
display the
Punch Unit Setting dialog box if the device listing is already enabled.
Select
2 Hole, 2 & 3 Hole, or 2 & 4 Hole punch option depending on the optional Punch Unit
attached to your finisher to enable hole punching.
NOTE
• Double-click the option to open the sub-dialog box if a device listing is
already enabled.
•The
Hard Disk Settings dialog box appears if you select the Hard Disk
option, enabling the configuration of virtual mailbox settings. For further
details, see Assigning Virtual Mailboxes on page 32.
To Next Page
Loading...
Need help?
General