Customization
18
Customize the Category Name
You can include the device version in the name, for example, XPort (R3) - firmware v6.1.0.0.
To include the device version:
1. From the Tools menu, select Options. The Options window displays.
2. Click the Customization tab.
3. In the lower section of the window, select Use the Device version as part of the device
category name.
4. Click Apply to save and leave the window open.
5. Click OK to save and close the window.
Customize Reboots
You can specify settings for the reboot process.
To enable the reset command and display it in the Device menu:
1. From the Tools menu, select Options. The Options window displays.
2. Click the Customization tab.
3. In the lower part of the window, select Enable reset commands and allow them to be
shown as menu items.
4. Click Apply to save and leave the window open.
5. Click OK to save and close the window.
To set reboot wait times:
1. From the Tools menu, select Options. The Options window displays.
2. Click the Customization tab.
3. In the lower part of the window, specify the following:
Device reboot wait
time (Unicast)
Select the number of seconds the unit should unicast
messages while waiting for a reboot. The unit attempts
a series of unicasts before broadcasting.
Device reboot wait
time (Broadcast)
Select the number of seconds the unit should broadcast
messages while waiting for a reboot. The unit attempts
a series of broadcasts after completing unicasts.
4. Click Apply to save and leave the window open.
5. Click OK to save and close the window.
To Next Page
Loading...
Need help?
General