LAUNCH Initial Setup
8
2 Preparations
2.1 Charging the tablet
1. Plug one end of the included power adaptor into the charging port of the
tablet.
2. Connect the other end to the AC outlet.
If
appears on the screen, it indicates it is being charged. If the logo changes
into
, it indicates that the battery is fully charged. Unplug the power adaptor
from the tablet.
2.2 Using your battery
If the battery remains unused for a long period of time or the battery is
completely discharged, it is normal that the tool will not power on while being
charged. Please charge it for a period of 5 minutes and then turn it on.
Please use the included power adaptor to charge your tool. No responsibility
can be assumed for any damage or loss caused as a result of using power
adaptors other than the one supplied.
While the tablet has low battery, a beep will sound. If it is very low, the tablet
will be switched off automatically.
2.3 Power on/off
2.3.1 Power on
Press [POWER] to turn the tool on.
*Note: If it is the first time you have used this tool or the tool remains idle for a long
period of time, the tool could fail to turn on. Please charge the tool for a minimum of 5
minutes and attempt to turn on again.
2.3.2 Power off
Press [POWER] for 3 seconds, an option menu will pop up on the screen. Tap
“Power off” to turn the tool off.
To Next Page
Loading...
Need help?
General
