GR30/GM30/GR50, Description of the System
26
2.6 Software
Description All instruments use the same software concept.
GR/GM series
software
Software upload
Software type Description
GR/GM firmware
(GR30_x.xx.xxx.fw/.zip)
(GM30_x.xx.xxx.fw/.zip)
(GR50_x.xx.xxx.fw/.zip)
The GR/GM Series firmware is called RefWorx.
This system software covers all functions of the instru-
ment.
The onboard web interface is integrated into the firm-
ware and cannot be deleted.
The English language is integrated into the firmware and
cannot be deleted.
Language software
(REF_LANG.sxx)
Numerous languages are available for the instrument’s
web server. Language software is also referred to as
system language.
The system software enables a maximum of three
languages which can be stored at any one time - the
English language and two other languages. The English
language is the default language and cannot be deleted.
One language is chosen as active language.
Software for Description
All GR/GM models All software is stored in the System RAM of the instru-
ment.
A new firmware file must be uploaded to the SD card
before installation. The file can be uploaded via:
• the web interface.
• direct copy to the SD card using a computer.
• FTP access to the SD card.
After uploading, the firmware must be installed via the
web interface. Refer to the "GR/GM Series Operational
Manual (Online Help)" for further information.
Leica GNSS Spider can also be used to install the firm-
ware. Loading the firmware to the SD card and installing
it on the instrument is done in one step when using GNSS
Spider. Refer to the "Leica GNSS Spider Online Help" for
more information.
To Next Page
Loading...
Need help?
General
